Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
jocopod [2016/01/10 00:04] – admin | jocopod [2016/04/12 11:06] (current) – admin | ||
---|---|---|---|
Line 1: | Line 1: | ||
- | **Jocopod** can be used to adapt an analogue PC steering wheel or joystick to the C64 control port and simulates up to two paddles there. | ||
- | ====== Manual ====== | + | {{: |
- | * Plug and unplug everything only when power is off! | ||
- | * Jocopod has two LEDs and two buttons to let you calibrate your input device. The button next to the green LED is Button 1, the one next to the red LED is Button 2 (there is also a separate reset button but this is normally not needed). | ||
- | * To calibrate a newly connected input device: | ||
- | - Press Button 1 until the green LED starts blinking rapidly (2 Hz). | ||
- | - Move all axes to their extremes *) (left, right, front and back). | ||
- | - Center all axes (center steering wheel or joystick, release throttle). | ||
- | - Press Button 1 or 2 or one of the joystick buttons to finish the calibration. | ||
- | - In normal operation mode the green LED is blinking slowly (0.5 Hz) and the red one indicates the center position of the X-axis. | ||
- | * The calibration is stored inside the Jocopod and has only to be repeated when changing the input device. | ||
- | *) Jocopod | + | Das Jocopod |
+ | * [[: | ||
+ | * [[: | ||
+ | * [[: | ||
+ | * [[: | ||